@eg4eric I DM'd my serial number to you. I had a few more instances of EPS overload when turning on the Microwave.

Same thing happening here as well. I think. Ran the update, appears to have been successful but still show one available.? Thanks, JB

I have a portable generator (20 amp; split phase) that was being used to power our home during grid outages for the past 8 years. It connected through...

EG4 does not have an inverter system for 24v.I have been using 24v for many years, although I use it asa basic UPS, just offline as long as the batter...

@frugal-farmer I have 3x EG4 Indoor wall batteries and the inverter has the bms current limited to 600A, so that should be more than sufficient to pow...

I noticed that the "current distribution" V18 firmware is still from November 2024. From this discussion, it seems an update is offered. When will...

I'd like to see this too.

Update: Just shy of 6 days since time set. clock now running 23 seconds behind.

What's your batteries capability? Voltage sags can easily occur when/if it is insufficient. Have you put a volt meter on your output when flickering i...

@eg4eric EAAB-201E Is the current firmware. It looks somewhat stable at -16 seconds over 4+ days. Thank you.

Oh... And what is the "power saver" setting ? ...... Need to know if I need it..... Thanks....

Got 'em hooked up and had no precharge issues.... Cool !! The settings on the 6000xp are a little daunting. Setting 1 for batteries.... Got the lithi...

I have a new install of an EG4 12kPV. I updated the software to EAAB-201C. I noticed the screen on the unit does not display the power flows. It sho...

Did you download the correct app?