Notifications
Clear all
Topic starter
December 22, 2024 10:17 pm
I have a Victron Multiplus II Inverter connected to a Victron Cerbo GX and then to an EG4 Wallmount battery. They won't communicate. I have upgraded both systems to the latest firmware and have the correct comm cable installed between them. Gee Beav, what gives?
thanks,
Dave
Topic starter
December 31, 2024 6:44 pm
I got this solved. It was just a matter of configuring the Victron communication port that goes to the battery to have the correct baud rate, 500 kbps, same as the EG4 battery.
Joel Brodeur reacted
