New to group/EG4...Installed 6000XP,nice setup,the usual non clarity of simple instructions to start and program.I'm 70 and not into apps,etc.I use my...

It discharges from 100 to 99, then it charges the batteries from 99 to 100(SOC). This is the cycle that its stuck in.

I have 2 strings of 6 (535W) panels each. Each string provides about 3kW at about 240-250V and are connected to PV1 and PV2. The panels, which are a...

Just for clarity my battery pack is using a single 100 amp bms that has active balancing with 14 3.7volt nominal cells in series. This is no different...

@bobro Do you have the wifi dongle setup to be able to use the website monitoring? There are a lot of setting and it can be easy to missing going thro...

Hi Jared thanks for responding. I did finally talk to someone at eg4 on phone and he also explained the three settings me in #6, so I did set the iac ...

System went down to 99% and now its charging the batteries again. Start Shaving SOC 1%...what should this be set at?

@bobro Have you tried through the app or EG4 monitor website?

Eric, I will setup both as you mentioned. I had battery backup disabled. I did not use the Forced discharge feature. I will change that. Thanks ...

Update to my issues. After trying everything under the sun to get these inverters to work on the new 1E1E firmware we had to replace the inverter with...

Hello Bobro, There are three setting under setting 6. The setting I have for setting #6 Ic 125 amp charge. #6 Iac is set to 1 amp. This would only lim...

@eric Thanks for the reply. I am confused by your statement "I can confirm that using batteries in series can sometimes cause issues with the inverter...

I’m not familiar with the wall mount batteries. All the settings you are talking about are programmed in my inverter. I believe most BMS’s look at vol...

@jareds I can confirm that using batteries in series can sometimes cause issues with the inverter, leading to abnormal operation.Regarding charging, o...