Eric, I will setup both as you mentioned. I had battery backup disabled. I did not use the Forced discharge feature. I will change that. Thanks ...

Update to my issues. After trying everything under the sun to get these inverters to work on the new 1E1E firmware we had to replace the inverter with...

Hello Bobro, There are three setting under setting 6. The setting I have for setting #6 Ic 125 amp charge. #6 Iac is set to 1 amp. This would only lim...

@eric Thanks for the reply. I am confused by your statement "I can confirm that using batteries in series can sometimes cause issues with the inverter...

I’m not familiar with the wall mount batteries. All the settings you are talking about are programmed in my inverter. I believe most BMS’s look at vol...

@jareds I can confirm that using batteries in series can sometimes cause issues with the inverter, leading to abnormal operation.Regarding charging, o...

EG4TechSolutionsTeam: "After reviewing the first remote set, I noticed that the LCD version is still on 12/1/1. Has it been updated to 18/1/1, as th...

@caesarv Where do you have your PV grounded? Also, are you running the inverter on Lead-acid for these batteries?

Good morning! Make sure Battery Backup Mode is disabled If Battery Backup mide is already disabled, you can set a time or battery percentage on ...

@jlankfordI don't see where they actually acknowledged the flickering in that post.

@bobandroslyn I was not supporting the idea. Of course, it is not recommended to remove the feet or switch them for casters. However, I'm sure there a...

> Dose Anyone here run grid as backup? If you do can you let me know if it is working properly and how is your gird backup is wired up?I'm running...

BobAndRoslyn, Thanks for your concern and input. I must admit my first gut response was that I'm not sure adding yet another "nanny warning" is neede...