It would also be worth noting that the Wi-Fi dongle will need to be on firmware version v2.06 for local SSID encryption.

Here is a list of special characters not accepted for the Wi-Fi dongle: Additional information can be found on our EG4 Wi-Fi Dongle Troubleshootin...

Yes again, There exists a set of common use-case scenarios (order of operations). For each of case there exists a few parameters (such as battery...

With the help from SignatureSolar, I received an answer: to control the remote start manually, grid power needs to be switched off. I turned off main ...

Yes.

That seems to be the general error code for attempting to change any setting to a value that's out of range or not allowed. I would guess you have som...

I was able to get it to work by changing my password using the app. I did remove most of the punctuation characters like =^-# out of my password. So u...

After further testing it seems as though some characters are accepted. I did use the app to change password and that did work. I did need to remove so...

For Wifi, take a look at section 7 of this doc:/p> As far as I know, there's no way to disable/secure bluetooth unless EG4 has recently added a pin ...

I have been using Program Setting 1 in SbU Mode, thinking I needed to prioritize "battery", but today I changed the system back to the UtI setting (de...

Note that the 12kPV is noticeably cheaper than the 18kPV and has a lower idle power consumption, so a win on both counts if you don't need the full po...