@eg4eric Unfortunately the Internet security practiced by EG4 is insufficient (no MFA among other things) so I can't leave the dongle connected. This ...

@weertske Unfortunately, this is currently not available to the public.

@dougl I am using the green terminal also but I disconnected the wifi just to remove variables.

@jlankford The Set record option is not available to end user accounts. You would need an installer account.

@weertske if you are using the RS485 port with the RJ45 connector(eithernet) then that shares with the WiFi dongle IIRC. I'm using the 2nd RS485 por...

@dougl I had the dongle off when this occurred. I'll try changing my read rate from 10 seconds to 60 seconds. Thanks.

I don’t have any and have never been around them, but 240 volt input is 240 doesn’t matter if it’s from the grid, generator or inverter. What is your ...

@weertske I do not have any parallel devices, just the 18KPV so maybe EG4 is using that rs485 port for parallel comms and there's too much traffic on ...

@EG4 Eric Please review my comment to Doug and let me know if you have any insight.  

@dougl I connected PPG to my 18kPV inverter and started reading the data (in ugly format) on Home Assistant. (I'll work on that later.) However, I als...

I am also looking for this information so that I can access data from both my 18kPV and my GridBOSS.

@eg4eric For this new feature, of auto charging 2Volts when cut-off voltage is reached I still don't know the default rate it should be charging a...

Since the 12000XP is an off-grid inverter, the current input limit from the grid cannot be adjusted.

  @eg4eric can you confirm if this settings change history feature is not supported for the 18Kpv, or is there something else wrong with my we...