From what I saw there was no proof they found anything. There were claims but no facts so without facts and verification it's just a boogeyman story ...

@eric, with the EG4 18kPV is it possible to greatly lower or eliminate the constant backfeed of power in on-grid mode by adjusting the CT adj setting(...

unless you have your inverters running different/isolated sub-panels I would think the way to do it would be to combine all batteries to a bus bar or ...

@eric thank you. It's an important feature for anyone wanting to use the inverters for NEM3 based export since the utilities are making it difficult t...

While the MaxBackFlow API message does set Grid Sell Back Power, setting it to Zero( 0 ) does NOT stop all sell back as shown in the data shot from a ...

oops, I'm monitoring FuncEn_EPSEn and it's remains set to 1 no matter if Off-Grid mode is enabled or disabled.

@eric can someone at EG4 tell me what's getting set on the inverter when the web page Off-Grid Mode is enabled and disabled? I'm monitoring FuncEn_E...

@eric So it sounds like Off-Grid mode = Enable will stop any and all export and import. It turns out this is a good thing since not only did we see a ...

@eric I noticed on our recent bill there were a few kWh of grid consumption power and I believe it's from little blips of grid power usage I see on th...

SOLUTION: @eric, never mind I believe I found it as ModBus address 103, MaxBackFlow set as a percentage of something. Im not sure what the percentag...

@eric is there a ModBus input-address associated with the "Grid Sell Back Power" setting? It really sucks that the Grid Sell Back Power setting...

@eric Thanks, I've come to that conclusion too and in the meantime I also learned that NEM3 sell-back rates are lowest during highest grid loading(4-9...