@ron I see a 56.2 among the charging specs, but I'm not sure that's relevant for assessing SOC when not charging. My battery currently indicates 84% ...

I thought EG4 recommended 56.2

I am in the same situation. How have EG4 not pulled this update...We are off-grid, well below freezing temperatures. Currently running generator so ...

@ron I'l be using the chart supplied by JLankford in an earlier reply on this thread. I don't regularly fully recharge the battery since mine is most...

What are the voltage settings everyone is using when utilizing voltage instead of SOC for the indoor wall mount batteries

Was this an upgrade from EG4_FAAB-1B1C to EG4_FAAB-1E1E by any chance? I've just brought batteries online a few weeks ago and added a 3rd battery la...

My concern with your setup would be what did you set at the low SoC trigger to stop discharging and why did your system not stop discharging at that S...

@kubota And it should be posted what the interface is.... RS232 means RS232 standard +/- 12V(15V sometimes)and UART tells it's love voltage but also n...

If you are off-grid then you must have a well/pump or you have a water tank you store your water in. If your water is in a well, you could pump water ...

You should post your working mode "Battery Settings" and i don't know why you would be using lead-acid mode for LiFePo4 batteries. I can see you do no...

How many amps does the trolling motor take?

The PylonTech( Pylon ) protocol is well supported so while the list shows lots of battery manufacturer names, check to see if the battery/BMS you are ...

Can the LUX protocol be installed on this EG4 inverter? Remember, I am a beginner here!!