The Z02T18 is the most recent firmware for the LL-S. The Z02T12 firmware is used to communicate with other batteries such as the LL-V2, Lifepower4 V1,...

If you have the protocol set to 0 on the inverter, you can try changing it to 1 and see if that helps. Just a warning that making this change will res...

Hey @ anyone with EG4... I need to dig this back up because the problem is STILL on going with no one even trying to troubleshoot or gather info.... ...

P.S. As the flickering is worse sometimes, and very minimal at others, I will see if I can isolate the cause to some device...such as my fridge, mini...

First, thank you for the reply.Many of my LED bulbs flicker constantly when running from the battery or solar. I have seen other posts that mention s...

What Firmware is your inverter on?Have you had this issue before, or did it just recently happen?Did you get any alarms while this issue happened?

Apologies for the delayed response. The inverter should automatically switch back to battery power once the battery voltage is at least +3V or the SOC...

Good morning! We have not had any reports of people having this issue with the new firmware.Can you please share more information about your system?Ho...

I found the answer on my own... you *can't* change the setting yet. It's listed in the "technical specs" for the inverter. The spec is listed as: LO...

The discharge cutoff must be configured through the inverter. The battery will continue powering loads until it reaches the discharge SOC cutoff.

@twistedroutes We apologize for the delayed response. Thank you for sharing this!

color/colour me shocked that no one had this... including anyone from EG4 or SignatureSolar... anyway, looks like it's a Metric thread: M12 x 1.75 (...