I'm out of ideas. Hopefully EG4 support will get involved with this thread. It's true the inverter will follow that max current parameter from the m...

rebooted everything. started with just the LL-S, waited until everything came back up, showed 50A/100A with 100Ah cap. Put 1 V1 in the loop, cap wen...

That's too bad. Did you reboot all, or just shutdown some of the batteries?

I have the same configuration, you use the multipack firmware. Also you need a special cable, connecting a standard cat5/6 cable between the LL-S and...

Good morning. I did all of that, the parallel number and capacity change, but the charge/discharge settings do not.

crickets. im going to have to look elsewhere.

I agree those are expected charge and discharge values for one LL-S battery. I would reboot everything. If you're unable to restart your inverter, t...

Per the mobile app it shows 6 batteries, 600AH capacity, 50A limit charge, 100A limit discharge. Number of batteries haven't changed. It is almost a...

Did the number of recognized batteries also change? Does the inverter still show 6 batteries and 600Ah of capacity? The new numbers look like only one...

I have the same need. I need to use 4 @ 44.65" (1134 mm) panels. The Cat 1 Mount System has a part number referenced as SKU: EG4BM25DEGKITV2. Have...