I feel like this has been discussed here before, so you may want to search the forum. I recall the advice from EG4 was to use a bank of three rack bat...

@brdfrd I prefer lead-acid mode for this.

That’s mostly correct. However, you might find this link to our API documentation for monitoring helpful: https://eg4electronics.com/api-documentation...

I will check to see if there is an update to this report.

Without looking at the system I would reference page 30 of the manual that talks about the return points for switching back to battery power. How...

If the generator's total harmonic distortion exceeds 5%, there’s a risk of damaging sensitive electronics and failing to charge the batteries using ge...

I know i can use one but not an option this time that is why my question.

I use a chargeverter just for that reason

I can confirm that I too see the behavior where the AC Charge setting changes from Enable to Disable after a Quick Charge cycle. It appears the Quick ...

@jared I think I found the BMS charging voltage value in the data history. I see a value named "ChargeVoltRef(V)", which is presently at 56.0V. Is ...

@jared Also, you didn’t answer the question about whether I should change charging control from “SOC” to “volt”. I’m inclined to change it to “volt...

@jared Thank you for your responses. Is there a way to see what charging voltage the BMS is calling for? The monitor displays the BMS charge curr...