To provide you with an accurate answer, I would need the following information: 1. List All Loads and Calculate Power Requirements Identify all ap...

What is the current set to in the settings?

Guidance for paralleling can be found in the manual, starting on PDF page 25 (or page 21 of the manual). For BMS communication, connect the master bat...

Thank You! I am on the phone with them now!

@bluetrader222, it's challenging to directly correlate voltage with percentage. However, 50.69V would not seem to indicate a 3% charge level. How many...

@charlesduckworth the code for Shop Solar kits is Shopsolar.

@dfwtinker I saw your "How not to burn up my equipment" post in another thread. It looks like you are doing 10 panels in parallel. You could do 2 sets...

3800w for 10 panels. Running 1 string to each inverter.

@charlesduckworth sorry, I’m not familiar with the installer code for them. Maybe @jared can help? Otherwise you would have to ask ShopSolarKits.

@w8dev Ahh, ShopSolarKit.com

@jared LifePower4V2, but no way to find current firmware version until I can get registered. And I have no installer code, as I am just installing my...

@stxsolar is there any chance you have helpful info on setup without battery back up ?

So I set my SOC to 1% but the voltage is 50.92V which is higher then the 3% SOC. I understand during discharging it will read lower and during chargin...

@david993561 my large house has a central ducted (forced air) “packaged unit” which burns propane for heat and grid electricity for summer A/C. I h...