EG4 Community Forum

Joel Brodeur
Joel Brodeur
@joel-brodeur
Reputable Member
Joined: October 15, 2024 8:48 pm
Last seen: June 18, 2026 2:13 am
Topics: 24 / Replies: 335
Reply
2 years ago
Reply
RE: Is it possible my 18Kpv CTs were mislabeled?

@jlankford I cannot see it. I a, probably being blind but I don't see a link to either. JB

2 years ago
Reply
RE: App login screen fails with "Network may have trouble" error

@jlankford Grasping at straws here.... Maybe permissions? I know when I set up my phone app and it was asking for permissions, I am pretty sure I ga...

2 years ago
Reply
RE: App login screen fails with "Network may have trouble" error

Neighbor 1 - Pixel 7 on T-Mobile, auto login enabled does get push notifications - Seen the error intermittently and the back out and re log in fixed ...

2 years ago
Reply
RE: App login screen fails with "Network may have trouble" error

@jlankford I have a couple of neighbors that also use the app. I will try to reach out to them and see if they have the issue as well. Might be a bi...

2 years ago
Reply
RE: App login screen fails with "Network may have trouble" error

@jlankford I use a Samsung S23 so pretty much a generic android but I know Samsung does do quit a few "Add-Ons".

2 years ago
Reply
RE: App login screen fails with "Network may have trouble" error

@jlankford Interesting (frustrating though). My app stays connected all the time and gives me push notification for events. I wonder if it is a phon...

2 years ago
Reply
RE: App login screen fails with "Network may have trouble" error

I have had this happen a couple of times to me. One time my Wi-Fi had decided to connect to the dongle instead of my house Wi-Fi. Still had cell ser...

2 years ago
Reply
RE: Vbus over range fault 18kpv

@wfbiggin Sounds like you found the beast. I almost wonder with the printer unplugged what your resistance is now between Ground and Neutral at the ...

2 years ago
Forum
Reply
RE: Is there a Remote Generator Start Function in the Dashboard for the 6000XP's?

That is one that is on my WISH list. 🙂 Fingers crossed???? JB

2 years ago
Reply
RE: Vbus over range fault 18kpv

@wfbiggin Yay! However, I would suggest trying (if you haven't already) different things plugged into that outlet and or try plugging that printer i...

2 years ago
Forum
Reply
RE: Runtime chart

That looks about right. According to the spec sheet the battery to invert efficiency is 94% and the non-standby idle consumption is approx. 50W. Dep...

2 years ago
Forum
Reply
RE: Vbus over range fault 18kpv

@wfbiggin If it turns out that it is just the living room circuit, I suggest you first check your outlets with an outlet tester, a decent one is not v...

2 years ago
Forum
Reply
RE: System configuration for a very low duty cycle UPS application

@davede as far as having the BMS completely control the charge cycle, I am just not certain. I am not extremely familiar with the detailed functional...

2 years ago
Forum
Page 17 / 24