I have seen and heard this said many times. Whenever I have questioned deeper, what they "seem" to mean is to perform a full cycle on the batteries a...

Had a similar issue when we first got our water system up and running. Wasn't able to get installed until late October and wasn't going to be able t...

Looks, fantastic. Sounds like cooling is a challenge in your area. For me it is heating. I just haven't found great solution. Yet...

I know exactly what you mean. I made some very $$$$ mistakes with my first system, and that was after 3 years of tutelage from someone that had made...

for clarification:

If the wiring is the same as the 6000xp, then the manual is correct. The RSD button, requires a NO contactor. The text with the image is regardi...

Panel inclination is measure as the incline from horizontal. So, if you are going to measure from a vertical mounting structure it would be 90 degree...

I have had remote updates fail and I was able to just re-run the process. However, I do not run parallel 6000xp's so my experience is with just a sin...

My 2-battery drift that way as well on SOC but definitely not that dramatically. I have seen posts on other forums about "resetting" the BMS's throu...

DOH Sorry but it is my best Homer Simpson imitation. 🙂 JB

Great catch. JB

Just out of curiosity, and I am sure you checked but, when you are checking voltage from L1 and L2 to Neutral, are you reading Vac or Vdc? The reaso...

@edo222 Nice looking setup! The wiring of the comms looks good. I have attached an image with an area circled. It appears that the comm wire has ...

Is that your battery discharge current? If so, and this is just a guess, if you are using closed loop to talk to the batteries, then I am guessing t...

Have you tried re-routing the comm cable, or maybe even a shielded cable (maybe it is getting some signal bleed from the power cables)? Also, if the...