Don't forget loss do to idle consumption (15W-70W 15 is standby so you are looking at closer to 70) and loss due to efficiency - (94% efficient batter...

@signaturesolarsupport It would be great to hear something on this as it is also an issue with the 6000xp. It is almost like when the gen gets the shu...

If you are using closed loop communications between the Batteries and the inverter you should be able to see the Bat count on the right side of the we...

Do you have a PV string(s) connected to that inverter? If so, use your disconnect and remove that string(s) from the inverter. Clear the error and s...

@m-piedlourde I am glad it is working but that is kind of strange. 🤔

Have you been able to connect the phone app to see if it is showing any warnings or alerts? JB

@pawnee I haven't seen @jared around the forum much but maybe @eric will chime in? JB

@pawnee I was browsing the 18K manual and came across this: regarding seamless switch. Didn't find much info on it, maybe the folks at SS could e...

Looks excellent! Great work. JB

@Pawnee You may want to look over the following thread: 6000XP generator transfer after charging – Page 2 – General Troubleshooting – EG4 Community F...

@ron I am in the same boat. During the summer I will cycle from 80% to 100% much of the time and then during mid-summer it will be more like 90% to 1...

@wiredup you might have a look at the following thread: @signaturesolarjess discusses a way to get the BMS to reset the high and low for the S...

1 - It is my understanding that there is no limit on the output from the generator. The system should only draw what the system can (just make sure t...

@95g-atl You can try filling out the form at - EG4 Technical Support - EG4 Electronics They should reach out to you.

@95g-atl Is this the charger? EG4 Battery Charger | 36V 30A - Signature Solar It indicates 30A? And it looks like you don't trust the light on th...