It was able to update with no issues. The current firmware is fAAB-1E1E. Three of my units have a capital F and three have a lower case f. Does the lo...

@dannybeardsley Can you post screenshots of your settings?@frugal-farmer Yes, you can! You have the option to keep it in bypass mode or configure it t...

@eric It is at the inverter under setting 22. It happened again yesterday so I gave SS a call. Running through some tests yesterday and today. Th...

Awesome! feel free to reach out to me if you have any questions or need any assistance. You can a contact us via email at [email protected]

Hey @joel-brodeur Where are you seeing the A25?

Its updating now.

Glad to see you got it resolved! If you need anything else or run into any issues feel free to let us know!

I was advised today about issues with updating the inverter’s firmware, but that issue has now been resolved. You should be able to update the firmwar...

Yes it is. I sent you a DM. Thank you.

Hi All. I was able to confirm that it was due to lack of knowledge on my part in regards to installation. I had set up the Panels in Parallel and not ...

@shm3lio Couple of questions, have you checked the following: With a voltmeter - are you getting voltage at the PV wires on the inverter end? Have...

2 different sized splices on the wiring to the panels tripped me up when I installed my setup. Are you sure you used the correct connector when adding...

Here is how I access logs on my batteries.

The team is currently conducting tests and is expected to get back to me in the coming days.