@eric You might note in that first linked thread that EG4TechSolutionsTeam acknowledged this flickering issue on 2 Dec 2024, post #34. For some 18...

> Did you get any alarms while this issue happened?None during this period. I do get a fair number of EPS Overload events because I have a discharg...

Firmware is at version: ccaa-180D0E. I tried to update 3 or 4 few times... but it always "Failed".This is the first time that I can recall this happen...

What do you mean by through the inverter? I suppose if the battery is connected to an EG4 inverter, and has CAN bus communication, then the SOC cutoff...

The Z02T18 is the most recent firmware for the LL-S. The Z02T12 firmware is used to communicate with other batteries such as the LL-V2, Lifepower4 V1,...

If you have the protocol set to 0 on the inverter, you can try changing it to 1 and see if that helps. Just a warning that making this change will res...

Hey @ anyone with EG4... I need to dig this back up because the problem is STILL on going with no one even trying to troubleshoot or gather info.... ...

P.S. As the flickering is worse sometimes, and very minimal at others, I will see if I can isolate the cause to some device...such as my fridge, mini...

First, thank you for the reply.Many of my LED bulbs flicker constantly when running from the battery or solar. I have seen other posts that mention s...

What Firmware is your inverter on?Have you had this issue before, or did it just recently happen?Did you get any alarms while this issue happened?

Apologies for the delayed response. The inverter should automatically switch back to battery power once the battery voltage is at least +3V or the SOC...

Good morning! We have not had any reports of people having this issue with the new firmware.Can you please share more information about your system?Ho...

I found the answer on my own... you *can't* change the setting yet. It's listed in the "technical specs" for the inverter. The spec is listed as: LO...

The discharge cutoff must be configured through the inverter. The battery will continue powering loads until it reaches the discharge SOC cutoff.