UPDATE: I hope I am not getting the run around here on a $1200 battery that worked for a mere few minutes. I was authorized for a full replacement...

sig solar has been good and quite knowledgeable on other issues. but if you need anything more eg4 escalation just tells me via email a week later to...

I am beginning to have my doubts about EG4 support. I had previously tried to get four more center-clamps for my Brightmounts and was told that they ...

Best to look them up. And actually, I have one more idea - what happens if you completely remove the LL-S and reconfigure all the comms to have a ba...

Good idea. That will at least let me charge the batteries until they can help address the issue. You wouldn't happen to know the values to set for v...

I'm out of ideas. Hopefully EG4 support will get involved with this thread. It's true the inverter will follow that max current parameter from the m...

rebooted everything. started with just the LL-S, waited until everything came back up, showed 50A/100A with 100Ah cap. Put 1 V1 in the loop, cap wen...

That's too bad. Did you reboot all, or just shutdown some of the batteries?

I have the same configuration, you use the multipack firmware. Also you need a special cable, connecting a standard cat5/6 cable between the LL-S and...

Good morning. I did all of that, the parallel number and capacity change, but the charge/discharge settings do not.

crickets. im going to have to look elsewhere.