You might need to update the firmware on the older LL batteries. The multipack on EG4 website. Need RS485 to USB communication cable and the RS232 t...

Are you concerned about the load the inverter itself is using? If yes, I have noticed the internal fans on my EG4 3000's to seem to cause battery perc...

I'm still struggling to determine your "problem". I have looked at page 55 in my manual and see nothing regarding an "AH" display. Also, again...what'...

EG4 3000 EHV-48.

I have gone through all the displays for Battery, grid and PV. Every screen is populated as it should be. I have also used the battery tool from EG4...

@eric That is what I have set up and all is now working fine. I got confused by this EG4 document. which shows using the RS485 port. There is too ...

Which inverters are you using?

Are you seeing any lights on or blinking on the dongle?

Here is a diagram on how to connect the batteries to each other and to the inverter. Also, having the inverter on Lithium brand "1" is the best protoc...

@quailfarmer If there is proper communication between the inverter and batteries it should show the AH. Have you tried clicking up and down on the arr...

I updated the firmware of the batteries, still no joy

it is recommended to cycle battery when on an on-grid net metering system which uses battery as back up to prevent long periods of time at 99%-100% SO...

I am looking for the assignment pin for BMS Communication Port for RS485 protocol vs. Conext-XW Schneider. To be able to access communication.