@jared Ah---thanks.

This is correct if your meaning is the same as my understanding... you will have a four wire connection from the inverter to the AC Disconnect - Line ...

@brdfrd you would only need to charge the battery bank in lead-acid mode once, until it triggers the battery overprotection warning once one cell hits...

Could you post the firmware version from the LCD display? Also, on setting 3, is the GNE setting available?

@jared The only issue with this, is that in lead acid mode, I cannot monitor SOC or remaining Ah capacity via the monitor center. Is there any issue w...

Here is my understand of my local jurisdiction's requirements for grounding solar panels. Keep in mind this is not a suggestion, not a recommendation...

I would make sure that the AC Charge is enabled with the Start AC Charge SOC and Stop AC Charge SOC configured.

@joel-brodeur I would hope that's not the case. Seems like the software engineers made a mistake if it is. Sounds like this would need a test with...

@jared thank you so much for reply! So, to recap: the wire #23 (+12 VDC) goes to NO1 the wire #194 (Transfer) goes to COM1 the wire #0 (DC Commo...

@jlankford @jared Additional thinking: If the above is true, then I think this would imply that the gen is getting a shutdown signal prior t...

The Dry1 dry contact ports are currently the only option for wiring a 2-wire stop/start with the GridBOSS. Dry2 is unused at the moment and reserved f...

I wonder if the problem isn't the switching speed but the range in which the switching occurs? Assumptions based on mentoring center (and a healthy ...