With the rated <70W in normal mode, you should expect to see roughly around 1.37A from the battery bank when powering idle consumption.A lot of BMS...

This depends on if BMS communication is being used or if the inverter is set to lead-acid battery type. With BMS communication, the charging voltage i...

@jared Photo of the batteries, above, with the dipswitch info...

@jared EG4 48v 100Ah LL-S (x4)I had been discharging in Lead Acid mode based on advice from Tech Support. I have to switch back regularly, just to che...

@brdfrd What lithium brand and battery protocol is being used?

Would you be able to connect the previous master battery to BMS Tools and post a screen shot of the reading?

Several wiring diagrams for the 18kPV in an ESS can be found on our website. However, the 706.15 regulation is typically the one referenced for rapid ...

@jlankford Thanks for the thorough explanation--much appreciated. Next visit to the cabin, I'll be adding another battery, and setting up the autom...

@bobandroslyn there would not be a warranty issue.

Testing is currently being done for the UL9540 and as soon as I have more information, I will make sure to post in thread.

Following up on this. I connected the com cable to Bat #2 and redid the dip switches on 2-10 so that #2 is actually #1 and so on. My 6000XP only se...

This is possible, but it’s important to parallel them to an external bus, ensuring the Ah capacity of each bank is closely matched. For example, you w...

@brdfrd You're correct that due to the flat discharge curve of LFP using voltage is not an accurate way to determine SOC, mostly between the range ...

My original purchase was a 4 pack of batteries and cabinet from SS. They all shipped together. Three batteries were on one version and the fourth on...

@jlankford Please forgive my ignorance, but I thought that voltage isn't an ideal way to determine SOC, due to how these batteries were designed to di...