@dougl I am using the green terminal also but I disconnected the wifi just to remove variables.

@jlankford The Set record option is not available to end user accounts. You would need an installer account.

@weertske if you are using the RS485 port with the RJ45 connector(eithernet) then that shares with the WiFi dongle IIRC. I'm using the 2nd RS485 por...

@dougl I had the dongle off when this occurred. I'll try changing my read rate from 10 seconds to 60 seconds. Thanks.

I don’t have any and have never been around them, but 240 volt input is 240 doesn’t matter if it’s from the grid, generator or inverter. What is your ...

@weertske I do not have any parallel devices, just the 18KPV so maybe EG4 is using that rs485 port for parallel comms and there's too much traffic on ...

@EG4 Eric Please review my comment to Doug and let me know if you have any insight.  

@dougl I connected PPG to my 18kPV inverter and started reading the data (in ugly format) on Home Assistant. (I'll work on that later.) However, I als...

I am also looking for this information so that I can access data from both my 18kPV and my GridBOSS.

@eg4eric For this new feature, of auto charging 2Volts when cut-off voltage is reached I still don't know the default rate it should be charging a...

Since the 12000XP is an off-grid inverter, the current input limit from the grid cannot be adjusted.

  @eg4eric can you confirm if this settings change history feature is not supported for the 18Kpv, or is there something else wrong with my we...

Thanks. That URL doesn't work for me - it just redirects back to the main monitor page. I guess the feature isn't supported for 18K.    

@jlankford Absolutely,