@dlwittsr I apologize for the delay. Is the RS485 protocol also set to EG4? If so, I would recommend changing this to a separate protocol.

@edo222 Nice looking setup! The wiring of the comms looks good. I have attached an image with an area circled. It appears that the comm wire has ...

Is that your battery discharge current? If so, and this is just a guess, if you are using closed loop to talk to the batteries, then I am guessing t...

Can anyone please help me understand whether or not Power on the load port is bi-directional or not? Thank you

Good to know

Yes I had problems because I didn’t know the app had more settings. A good example is I couldn’t get my generator to charge the batteries above 3000 w...

@jared thanks. The Tec guys at Signature solar discouraged me from using SOC so now I’m not sure what to do

Well, for anyone watching this thread, you have as much info as I do from EG4 (above), but I've talked to CurrentConnected a couple times on the phone...

I think my real problem may have been EPS overload and not merely loss of parallel communications. I try to set the discharge current limit to 280 ins...

@jared I turned off the EPS switch on my 6000XP and the unit kept producing solar. So I opened the bottom panel and sure enough, I was getting 12 vol...

I'm seeing posts that recommend not charging past 80% and 53.3V is about 90%

I have (finally) been able to approximate a LFP friendly charge curve with the 6000xp charge controller running the show 'open-loop' (without rj485 co...

If you have multiple Lifepower 4 batteries in parallel. They will likely drift apart on SOC if not charged above 80%.