@grissam-solar I used a bus bar since the Chargeverter comes with a ring terminal on one end and I didn't have the correct tools to put the amphenol c...

My system is One EG4 18k inverter with two All-weather pro outdoor wall mount Batteries. The system is hooked up to the grid also for charging the bat...

@joel-brodeur thanks. I’m going to contact Tec support and double check. I’ll make a post and see what EG4 says. I’d love to she a SOC vs Volts chart ...

@pawnee When I used FLA I too was told to never use SOC. However, with my old system I found that with proper bi-annual maintenance (re-torquing all ...

@jared A follow up on this. My generator ran today and seemed to have charged everything in the expected manner. However, the generator shutdown...

Had the same issue, I took my inverter to my provider (Current Connected ) they took care of it in few hours, they said when I tried to update the fil...

I found the cables that shipped with my batteries are rated right. I decided to over build it, I changed all the leads to 2 AWG. and the output of...

According to the manual I think this is a battery communication fault. What type of batteries are you using? Could you post pictures of the comm conn...

Raised to 56V and now it goes all the way to 100Amps. Is there any way to have it communicate with the batteries that use Pylon protocol on RS4...

Looks great. The 18k is a fantastic inverter

@jared thanks I’ll look for it and try and send it.