EG4 Community Forum

Anonymous
Joined: July 11, 2026 8:38 pm
Topics: 7 / Replies: 19
Reply
RE: Interview with EG4: Talking All About the GridBOSS & FlexBOSS21

This is possible, but it’s important to parallel them to an external bus, ensuring the Ah capacity of each bank is closely matched. For example, you w...

2 years ago
Forum
Reply
RE: 6000xp Balancing issue--how to correct?

@brdfrd You're correct that due to the flat discharge curve of LFP using voltage is not an accurate way to determine SOC, mostly between the range ...

2 years ago
Forum
Reply
RE: 6000xp Balancing issue--how to correct?

My original purchase was a 4 pack of batteries and cabinet from SS. They all shipped together. Three batteries were on one version and the fourth on...

2 years ago
Forum
Reply
RE: 6000xp Balancing issue--how to correct?

@jlankford Please forgive my ignorance, but I thought that voltage isn't an ideal way to determine SOC, due to how these batteries were designed to di...

2 years ago
Forum
Reply
RE: 6000xp Balancing issue--how to correct?

@brdfrd FYI, I have a battery bank of LL-S which is currently showing 98% (five batteries at 100%, and one at 90%). In reality, based on voltages, ...

2 years ago
Forum
Reply
RE: 6000xp Balancing issue--how to correct?

@coryell-offgrid That's a good question. I bought them all at the same time, I updated the firmware on the inverter, not sure if that also updated the...

2 years ago
Forum
Reply
RE: EG4 Battery Bank Settings for Victron Lynx Shunt

Thank you! I have charged the batteries using the victron multiplus but on the Touch GX (connected to the Cerbo GX) both the Shunt and the Multiplus ...

2 years ago
Reply
RE: 12kpv smoking

We are currently experiencing a delay in responding to emails due to a high volume of emails in our support inbox. Could you DM me the email address y...

2 years ago
Forum
Reply
RE: 6000xp Balancing issue--how to correct?

@jlankford Thanks. That is interesting, if it's the case. The battery gauge on the battery, as well as the info displayed on the screen all jive with ...

2 years ago
Forum
Reply
RE: Installer Code Needed For Installer Who Doesn’t Know The Code

Where did you purchase the inverter? We provide specific installer and distributor codes for each of our authorized distributors and registered instal...

2 years ago
Reply
RE: 6000xp Balancing issue--how to correct?

@brdfrd Based on your last screenshot batt data, I think you are seeing the same problem as me. In reality, the batteries are remaining in sync and...

2 years ago
Forum
Topic
2 years ago
Forum
Replies: 1
Views: 740
Reply
RE: 6000xp Balancing issue--how to correct?

Are all of the batteries on the same firmware version? I had a similar issue when I first installed. I had to update had all batteries on both comms...

2 years ago
Forum
Reply
RE: Installer Code Needed For Installer Who Doesn’t Know The Code

@joel-brodeur Unfortunately the reseller could not provide either. Hopefully EG4 can respond to my request.

2 years ago
Reply
RE: Installer Code Needed For Installer Who Doesn’t Know The Code

@nwazog Your installer will need to contact the reseller to get the code. The code is different for each reseller. JB

2 years ago
Page 339 / 407