LCD V18 Changed the Gen overload on the alarm error page to AC overload. Changed the Meter type to Meter brand on advance interface. Modified th...

@herreraa, the charge current might be restricted through the settings, or the BMS could limit it based on the state of charge when communicating with...

@daddydoug33 can we please get a pic of your yellow and red PV switch on the right side? Oh, forgot to mention that you might want to check page...

a 120v circuit needs the neutral to complete the circuit. A 240 volt does not. For the inverter to function correctly on 120v you need to bond at the ...

Silly question but I have to ask. On the right side of the invert there is a big red rocker switch. What position is that in. Could you post a pic?

@joel-brodeur I just trying to get the solar to do anything. I have no grid connection so there is the generator for ac charge mode, and the pv solar...

How many amps are you trying to draw. Everything looks set up correctly as far as I can tell from the pics. When you say AC charging do yo...

Thank you both for your comments. Joel is correct that what I wrote earlier means there is no NG bond at the generator - it was checked with a meter. ...

That makes sense. Thank you. To further the question, for touch potential, wouldn't you want the gen and chargverter to be at the same potential as...

I'm not sure what you mean by loads. The terminology to me means something else. I'm trying to learn as much as I can so I appreciate the explanatio...

@joel-brodeur here is the pictures.

@tristan I try to have all release notes added to this section of the forum: Firmware Updates – EG4 Community ForumHowever, I will see if I can find c...

Joel, Bonding means neutral connected to ground. In a ground fault situation you want the current to follow through the ground wire until it finds the...