I know i can use one but not an option this time that is why my question.

I use a chargeverter just for that reason

I can confirm that I too see the behavior where the AC Charge setting changes from Enable to Disable after a Quick Charge cycle. It appears the Quick ...

@jared I think I found the BMS charging voltage value in the data history. I see a value named "ChargeVoltRef(V)", which is presently at 56.0V. Is ...

@jared Also, you didn’t answer the question about whether I should change charging control from “SOC” to “volt”. I’m inclined to change it to “volt...

@jared Thank you for your responses. Is there a way to see what charging voltage the BMS is calling for? The monitor displays the BMS charge curr...

Thank You @Jared for your responses here and in my other thread. So this is beginning to make sense to me. The EPS idle current of 1.37A DC, distrib...

@jared In lead acid, or lithium mode?

@jlankford Thanks. I have 2 batteries now, at 25 and 28%, with min cell voltage at 3.206v, 3.207v, respectively. The whole system will be set to st...

@brdfrd I would set charging to based on voltage to make sure that the cells reach the overcharged warning protection.

The minimum amount of discharge amperage reported is 0.5 amps DC.

@brdfrd Keep an eye on your cell voltages so you don't accidentally run one or two of the batteries into the ground. With the reported SOC numbers ...

@jared I'm not at the cabin until this weekend. I'm going to have to put it on stand-by, remotely, tomorrow. I have 2 of the 4 batteries at 28%, and 2...