@jlankfordI don't see where they actually acknowledged the flickering in that post.

@bobandroslyn I was not supporting the idea. Of course, it is not recommended to remove the feet or switch them for casters. However, I'm sure there a...

> Dose Anyone here run grid as backup? If you do can you let me know if it is working properly and how is your gird backup is wired up?I'm running...

BobAndRoslyn, Thanks for your concern and input. I must admit my first gut response was that I'm not sure adding yet another "nanny warning" is neede...

@twistedroutes and @eric, this seems like a REALLY BAD IDEA! Those batteries are 300lbs. I would expect EG4 would take a more cautious stance on use...

@eric, information sent via private message.

You are able to do AC couple, which allows the user to add PV from an existing grid tied solar system. You would need to connect the output of the exi...

@bobandroslyn Putting the inverter in Lead acid mode is the best way to balance out the batteries. Unfortunately, I’m unable to clearly see the screen...

That’s great to hear! If you need anything else or encounter this issue again, please let me know!

I'm intending to do the same thing but with a 12kPV inverter and an existing grid tied system that uses Enphase IQ 6/7 micro-inverters. EG4 support sa...

@eric You might note in that first linked thread that EG4TechSolutionsTeam acknowledged this flickering issue on 2 Dec 2024, post #34. For some 18...

> Did you get any alarms while this issue happened?None during this period. I do get a fair number of EPS Overload events because I have a discharg...

Firmware is at version: ccaa-180D0E. I tried to update 3 or 4 few times... but it always "Failed".This is the first time that I can recall this happen...