EG4 Community Forum

Bluetrader222
Bluetrader222
@bluetrader222
Eminent Member
Joined: October 17, 2024 3:19 pm
Last seen: May 14, 2025 1:16 pm
Topics: 7 / Replies: 21
Topic
Reply
RE: EG4 Wall Mount Pros (Optimal Settings for Optimal Performance and longevity

Here are SOC vs Voltage... I was taking the battery down to 46v based on setting one of the EG4 tech guys ..but that is too low. so wanted to see taki...

10 months ago
Forum
Reply
RE: EG4 Wall Mount Pros (Optimal Settings for Optimal Performance and longevity

SomeJ this is very very useful information and these curves is exactly what I am experiencing 50 to 54 is like bulk of the range 10% to 90% 46 to 50V...

10 months ago
Forum
Reply
RE: EG4 Wall Mount Pros (Optimal Settings for Optimal Performance and longevity

So here is a screenshot of my Inverter Sol Ark 15K Closed Loop stating 10% SOC = 50.6V. Is this the true 10% SOC at this voltage? I don't know. Does E...

10 months ago
Forum
Reply
RE: EG4 Wall Mount Pros (Optimal Settings for Optimal Performance and longevity

I did switch to close loop and trying to figure out the details. For the EG4 Wall Pro spec sheet, what voltage (V) for a 10%, 0% state of charge? ...

10 months ago
Forum
Reply
RE: EG4 Wall Mount Pros (Optimal Settings for Optimal Performance and longevity

Hi Jarrett, Then what should the Float be? The spec see says charger setting for float is 54V+/- 0.2. So 54-0.2 =53.8V Sorry what is 80% DOD?...

10 months ago
Forum
Topic
Replies: 2
Views: 1108
Reply
RE: EG4 Wall Mount Pro Battery Received in Protection mode

Today I went back to the battery to check on it and it went back in protection mode. I went on the onsite screen to the cells to see the mV and notice...

10 months ago
Reply
RE: EG4 Wall Mount Pro Battery Received in Protection mode

Working with the distributor to get this replaced. The other 2 batteries I have are impressive. Thank you EG4 for making them.

10 months ago
Page 2 / 2