@fkitzmann & @montufar You are both correct! A second battery was required! You will find the results of adding that battery here ==>/p> ...

Good Morning @dougl I totally agree that you would get far better results. However adding that single variable complicates the behind the curtain ...

I wondered the same thing. Perhaps they should allow a system setting of a "prediction multiplier" that uses the historical data. In my case, because ...

@eg4newbie your 12000xp still isn’t changing the battery BMS from the 200 amp discharge setting is it? On battery only and balanced lines you can ...

Also, is the area that shows the time span supposed to be showing a On/Off graft or something for that function? Seems to be blank but I don't know wh...

Additional issue with AC Charge Mode, AC Charge Enable is that when it's enabled, no power will be supplied by the battery and it only gets supplied b...

I'm also having a similar issue with Working Mode Setting, AC Charge Mode (AC Charge Enable) being inadvertently ENABLED. My system consists of an 18k...

Looks like you have enough solar but you cant use it all with your loads at the time that your solar is producing. Your battery gets charged up and ca...

Your EG4 24k is efficient, but constant HVAC draw transforms the system into a daily deep-cycle challenge—especially in winter. You’re seeing exactly ...

Unless of course that I'm wrong and this inverter isn't intended to provide continuous power and thus should only be used in "Emergencies" or as a "Ba...

Well in the time waiting for moderation as a new user, I updated the firmware from ceaa-000202 to ceaa-0405. Not sure this was the solution, but I've...

@slackware1995 Hey, really appreciate you taking the time to break all that down—it helped a ton. You were spot-on about the grounding. I’ve actual...