What about auditory behavior of 12kVP vs 12000XP?

(that last comment should read "800W" not 800 kW!) My worst case steady state load is about 700W, for which silence would be a huge plus. The stri...

@jared To clarify on "Left and Middle Fans: Activate when charging or discharging power exceeds 300W", does that mean PV power input also? In other w...

Can you share a picture of your current settings?

@jared WOW, that's fantastic information, just what I needed. I have eight (8) X 540W solar panels in a string, so production much of the day is lik...

As both cables are black, I wrapped a piece of white tape around the same wire on both ends. Both wires are STP Cat6a. I started with unshielded CA...

Could you share a few pictures showing how the batteries are connected, the dip switch settings, and confirmation that the V1 is not communicating?

I will see if I can find the fan dB rating for the 3000EHV. However, here is the fan control logic for the 6000XP and 18kPV:6000XP Fan Control Logic: ...

Could you post a picture of the paralleling cables and dip switch configurations for both the GridBOSS and FlexBOSS?

Setting 43 would be the correct setting to initiate charging with the 3000EHV. However, as mentioned, the maximum initiation threshold is 50%.

Would you be able to DM me the serial number for the Wi-Fi dongle? I can take a look at this as well.

@brdfrd OK, that's what I was expecting. My system sits in EPS standby and consumes about 1.8 kW per day from the battery. With that low current ...

@brdfrd Here is my experience with Auto Gen start: The gen appears to start when the inverter shows below the set SOC Start, not when a battery hits...

@jlankford adding this: average continuous current discharge is 45-60 watts.

@jlankford Well, right now, it's 1.3-1.5kWh--just running wireless internet and security cameras. That's all I dare run at the moment. Solar produc...