@jared Performed a firmware upgrade. All my problems are solved, for the moment. THANK YOU!

Thanks everyone for the feedback. For this situation, with some critical loads that don't handle the switching well, it sounds like using a chargever...

@jared Cannot seem to get past the registraion since the Dongle information is already in use? How would i register them as i am the installer? Sorry ...

@jared

I do not have the Generator option for Setting 3.

@jared Ah---thanks.

This is correct if your meaning is the same as my understanding... you will have a four wire connection from the inverter to the AC Disconnect - Line ...

@brdfrd you would only need to charge the battery bank in lead-acid mode once, until it triggers the battery overprotection warning once one cell hits...

Could you post the firmware version from the LCD display? Also, on setting 3, is the GNE setting available?

@jared The only issue with this, is that in lead acid mode, I cannot monitor SOC or remaining Ah capacity via the monitor center. Is there any issue w...

Here is my understand of my local jurisdiction's requirements for grounding solar panels. Keep in mind this is not a suggestion, not a recommendation...

I would make sure that the AC Charge is enabled with the Start AC Charge SOC and Stop AC Charge SOC configured.