@joel-brodeur If I don't have a fault by tomorrow I'll check on that just for curiosity sake.

@wfbiggin Sounds like you found the beast. I almost wonder with the printer unplugged what your resistance is now between Ground and Neutral at the ...

@joel-brodeur I had that thought too and moved the printer over to the kitchen, sure enough given about 30 seconds or so for the printer to go through...

That is one that is on my WISH list. 🙂 Fingers crossed???? JB

@wfbiggin Yay! However, I would suggest trying (if you haven't already) different things plugged into that outlet and or try plugging that printer i...

When do you expect to have Flexboss 21 and Gridboss certified for Ontario, Canada? Thanks, and looking forward to installing them!

@jared @jlankford @joel-brodeur After a bit of testing I am 80% certain that I found the problem. Tested all the outlets on that circuit and the...

Hi Jared, It seems to be much better. It's been 2 weeks and it only happened once.

@jared The system has now gone offline with the last battery voltage recorded as 52.2v. could you try and look into this as I can’t see why two new...

When I install the CTs according to the label, here is the reading I get which is nonsense because this would mean I bought a perpetual motion inverte...

Well that was an unexpected break! Cable at the property went down around 1105 DST on Wednesday. Turns out the cable had been broken 40 foot from t...

@wfbiggin I expect all the lights in the RV are 12VDC so none of them should be on that living room branch circuit. Are there actually some lights ...

That looks about right. According to the spec sheet the battery to invert efficiency is 94% and the non-standby idle consumption is approx. 50W. Dep...