Thank you for the suggestions. It is looped inside a chase with a lot of energized wires. I hope I can get the cable outside of the chase as the inver...

Thanks Joel, I rewired the array to produce 220V and it is operating now.

Have you tried re-routing the comm cable, or maybe even a shielded cable (maybe it is getting some signal bleed from the power cables)? Also, if the...

From the spec sheet. Min 100V +- 10V for start up. Min operating 120V Hope this helps, JB

Thank you for the quick information! Unfortunately, still no detailed battery data or battery breakdown tables on the monitoring site. All 4 batt...

And, if you are looking for a crimp tool, here's a comparison of some options at different price points...

Sun came out today and charged system to full.... verifying that the charge curve is NOT doing what I programmed. The 6000xp is holding end-of-charge ...

You can find the firmware file at the following link: Allweather Firmware

Thank you. All batteries are version Z02T13 - so they all need upgrading. Where is the file? I was also advised earlier by S2 phone call to set CAN ...