@Eric Thank you for the update

@joel-brodeur it didn’t switch back and forth from batteries to generator during shutdown. Generator stopped charging then switched to the batteries b...

@eric Iam trying to update to LCD firmware 18/1> I am using a USB flsh drive it has been going on for 45 minutes. The USB light is flashing like it...

@joel-brodeur I shut the panels off Tuesday night and the gen should about be ready to start, so I’ll let you know in a few hours.

@pawnee were you able to enable cool down? Did it help any?

@eric Bump the question.

@eric Visited with Jacqueline at SS tech support (awesome working with her, please tell @signaturesolarjess that Jacqueline deserves a raise after dea...

Here's another example from today where it stayed in bypass mode for a while with loads that could easily be handled by solar *or* PV.You're welcome t...

One Flexboss should be sufficient, but it ultimately depends on your required output. Having two will provide more power, and you’ll have the flexibil...

It was able to update with no issues. The current firmware is fAAB-1E1E. Three of my units have a capital F and three have a lower case f. Does the lo...

@dannybeardsley Can you post screenshots of your settings?@frugal-farmer Yes, you can! You have the option to keep it in bypass mode or configure it t...

@eric It is at the inverter under setting 22. It happened again yesterday so I gave SS a call. Running through some tests yesterday and today. Th...

Awesome! feel free to reach out to me if you have any questions or need any assistance. You can a contact us via email at [email protected]