@joel-brodeur Will the 6000 boot up and run on just battery power? I assume it will, just like the 18K... I scanned through the thread but don't ...

@jlankford I do have a large gas generator but would prefer to use one I can plug into a standard outlet. I dont want to do any additional installatio...

@mylesj From what I have seen the EG4 chargeverter is a great solution:EG4 Chargeverter - GC | 48V 100A Battery Charger | Signature Solar BTW...

@jlankford Thank you! It looks like that definitely a factor! I was going to invest in a charger. Do you have any suggestions on the 48v battery ch...

@mylesj Based on the audio, that sounds like a relay is switching something. Maybe some setting conflict but I don't see which it is. I would sugges...

@mylesj The flickering may be because your batteries are very low now. 45.9V in that video is about 5%. See the voltage chart I posted in a differe...

@mylesj One more thing... your batteries are NOT at 55% SOC or anywhere close to it. They are near dead. 47.6V is less than 10% SOC. This is related...

@joel-brodeur Hello and yes there was a system reboot after the settings change. I have also lost my power now. And I connected the inverter to my ...

@jlankford Hello and yes there was a system reboot after the settings change. I have also lost my power now. And I connected the inverter to my tran...

@joel-brodeur I looked at the manual... it appears that function is just incorporated into the single "AC Charge Based On" setting for the 6000. ...

@jlankford On the 6000 the "AC Charge Enable" is not an option. I am assuming that since there is no sell back that the option is always on. (just an...

@joel-brodeur On the 18Kpv, there is a setting "AC Charge Enable" which I do not see in the above screen shots. Is that not a setting applicable to...

@pawnee Glad the update fixed the Gen run, did it also fix the Watt readings? Hopefully @eric has some news or suggestions on the hard handover. J...

@mylesj I am guessing you can't disable it. Maybe just set your gen start SOC to something like 20%. Also, if you haven't already, you might try, r...

@joel-brodeur Hello Joel, I tried you suggestions and it did not work. I have tried to disable the generator setting and it wont allow me to do it...