@joel-brodeur thanks. I’m wondering if that is my problem because it doesn’t cooldown it just kills the gen as shown in my brownout video.

@pawnee The gen cool down for the 18K should be under the gen settings: As far as what to set it for, you might look into your Gen manual. Dif...

Eric asked me about Gen cooldown but didn’t elaborate. I’m going to put my system on the monitoring website this weekend and look for that setting. Wh...

Are both legs balanced out?This could also be because there is too much load on one leg.

@eric any update Eric? Are y’all able to recreate our issue in the lab?

Fascinating read, thank you for sharing. This makes a lot of sense. I'm concerned that the relays are being opened for overcurrent protection when the...

As a follow up, it is now going to get difficult for me to perform further tests for a while. We have started getting sun again and my solar will typ...

Probably related to this issue. It sounds like there is a software fix, perhaps not released in an official build yet...

@eric I have never had Gen Boost enabled.

got it running.... portable power in a 63gal toolbox: 10kwhr-eg4.3k 120v AC inlet for charging from grid PV input for charging from PV AC out ...

@joel-brodeur Have you tried enabling Generator Boost?@wardo5757 Understood! I'm trying to gather as much information as possible. Thank you for being...

@eric Is the battery type something you can remotely change? This inverter is very remote ...... I thought it was 0 for EG4 on the 6000xp and 1 for 12...