@95g-atl That would be great. I am not certain if it will show faults or not, but it is worth a try. In the meantime, would you have the make and mo...

@joel-brodeur thank you for the replies and help. My son is more of the expert than i am on your Q's. He said last time he charged it from und...

@95g-atl would you be able to provide make and model of trolling motor or a link to the specs. In general, it kinda looks like something is triggeri...

@joel-brodeur 52 amps

@joel-brodeur So here are the steps to deep cycle the batteries, but I do recommend calling into our tech support department to provide the eg4 inv...

I'm still using SOC and I initiated a manual charge with the 6000xp for 2 ea. wall mounts. The inverter was only showing 55.9 volts at 100% and then s...

right now I am reading (from inverter) 100% at 54.8V..

I have 2 EG4 indoor wallmount batteries (Lithium). When at the same voltage one will have an SOC different from the other by 8-10%. I think I need t...

It is currently on firmware faab-1112.

FPO (for placement only) so that i could get measurements for raceway and figure out security. More to follow. I intentionally tilted the intern...

12000XP is in Standby state 🙁 Turn off EPS, turn off inverter Turn on the generator. Optional that I do or my lines would freeze Turn on...

@signaturesolarjess Is there a TSB for performing a calibration - resetting SOC - for the different type of EG4 batteries? I would love to get mine...

@ron I don't know what battery cells you have but the manufacturer of my cells, EVE, state that the min low voltage is 40V(2.50V each) on the pack of ...

According to EG4, once you go to 1E1E, you cannot go back. This is due to an updated memory mapping.