Woah! The latest firmware (released today!) Seems possibly to have fixed the problem!Not a single EPS overload today!

For the Lifepower-V2 you can use BMS TOOLS using the RS-485 cable (pins 1 & 2) if you don't have this cable let me know and i can provide one for ...

Are you charging and discharging batteries by voltage? Meaning you have Voltage parameters set on the inverter.

@jared Well, after much noodling and acumulating all the pieces and parts, here is where I am Firmware is updated on 3 batteries to Z02T17 The dip...

Installed transfer switch before chargeverter to utilize grid or generator and set to 57v.

Yes sir. I too was delayed in getting back out to the property. I finally made it out and changed the settings. It looks very, very good, especiall...

Monthly does seem a bit excessive! and the equipment might be pricy for quality stuff. I agree, there must be an easier way. The answer should ...

Email me directly and I'll give you my inverter number and you can look it over

I think my settings were wrong and I kept blowing my 60 amp battery fuse, when that happen the negative was intact and the inverter read my voltage wr...

@eric yes, only the v1 batteries, but not the v2 batteries

Currently, there is no LCD firmware update available, but we will let everyone know as soon as there is.