EG4 Community Forum

Frugal Farmer
@frugal-farmer
Eminent Member
Joined: October 19, 2024 2:37 pm
Last seen: March 30, 2025 2:14 am
Topics: 2 / Replies: 19
Reply
RE: Install clearances

Couldn't you mount some din rail on the wall to gain more clearance? Toggle bolted inverter doesn't sound secure to me for long term purposes.

3 days ago
Reply
RE: Curious behavior - Batteries charging with BMS Charge forbidden

Is that a screen shot from the front of your controller? If yes, perhaps since your batteries are at 100% your (BMS?) required charge is not needed?

1 month ago
Forum
Reply
RE: Setup New System but Solar Not being Recognized

2 different sized splices on the wiring to the panels tripped me up when I installed my setup. Are you sure you used the correct connector when adding...

1 month ago
Reply
RE: 6000XP Not exiting bypass mode for hours

Is it possible to program that inverter to not go into bypass mode when fully charged or slightly loaded? Curious minds wish to know!

1 month ago
Forum
Reply
RE: 6000XP Inverter shutdown when batteries hit 100% on solar A25

Please elaborate on "shuts down". Are you saying it turned itself completely off momentarily? I don't have the 6000XP but instead 2 3000's and when t...

1 month ago
Forum
Reply
RE: EG4 3000EHV-48 for Time of Use Charging

Did you happen to notice if it is programmable to put it's self in Stand By mode also during times and upcoming dates? Internal power consumption on t...

3 months ago
Reply
RE: Unable to Use a Generator except in Stand-By Mode

Thanks, yes...3 is a GNE. We have finally figured out what was stopping utility/generator charging when NOT in "standby mode"! A tech over at Signa...

3 months ago
Reply
RE: Unable to Use a Generator except in Stand-By Mode

16 is at SNU. Thanks but checked that already. Guess I will call Signature Solar soon. If they can fix these with software I will report back here wha...

3 months ago
Reply
RE: Unable to Use a Generator except in Stand-By Mode

Anyone else notice this or are you able to use electricity when using a generator to recharge your batteries?

3 months ago
Reply
RE: EG4's in "split phase"

Anyone else out there have this same (#1) issue with these inverters or do I have a setting wrong. Seems odd the manufacturer would disallow generator...

3 months ago
Reply
RE: EG4 wifi dongle unable to connect

Please post the fix once accomplished here!

3 months ago
Reply
RE: Change in self consumption

Are you concerned about the load the inverter itself is using? If yes, I have noticed the internal fans on my EG4 3000's to seem to cause battery perc...

3 months ago
Forum
Reply
RE: EG4-3000ehv not displaying battery AH capacity, screen is blank in that area

I'm still struggling to determine your "problem". I have looked at page 55 in my manual and see nothing regarding an "AH" display. Also, again...what'...

3 months ago
Reply
3 months ago
Page 1 / 2