Are you sure that it is warning 25 and not error 25 (over temp)? You might check your air filters and make sure they are clean and that your inverte...

@wardo5757 My old system did handle gen switching much better. However, it was a conglomeration of vendors. My inverter was a Magnasine which I did ...

@wardo5757 I have not been able to check it out since the last firmware. I need to run a down up cycle one of these and see what happens. Just hard...

@eric Bummer. Think you might ask the testing folks to maybe try it out?? 🙂

The easy answers to 1 and 2 are - yes - if the settings are correct. For 3 - I would highly suggest trying to keep the system withing the operating ...

@eric thanks for the reply. I guess I have what is probably silly follow up questions that you might be able to answer: Could I do the following: ...

@ac130buff Yes, the SW switch is for an external RSD button. If you don't have Tigo, you can ignore the rest of the diagram.

@dannybeardsley I should have been more clear. On my system the with the indoor wall mount batteries, it trips the breakers on the batteries breakers...

To connect an RSD to the inverter, connect like this: When the button is depressed, the inverter will trip the battery breakers and shut down the ...

@dericwright Well, I tried, sorry sir, maybe one of the EG4 folks might chime in.

@dericwright I am assuming you did but I have to ask. By chance did you make sure to: 1 - Turn off battery breaker before trying to set protocol 2...

To enter service mode press and hold the return key for 5 seconds not the enter key.

It appears to be a legacy battery: EG4® LL 48V 100AH Lithium Iron Phosphate Battery

@teeumup Click on red first then on green