EG4 Community Forum

Anonymous
Joined: September 15, 2025 6:57 pm
Topics: 2 / Replies: 14
Reply
RE: Lifepower V2’s

47V is definitely not 0%, but it is considered below 20%. Voltage is a more accurate reading because the inverter measures it directly from the batter...

6 months ago
Forum
Reply
RE: 12000xp and warning 28

That was my thinking as well. If I push the reset button the default setting is 10%. I’ve been increasing this setting by 10% after the inverter goes ...

6 months ago
Forum
Reply
RE: 6000XP Not exiting bypass mode for hours

Not yet, but I'm working on creating a large battery box with 12 Tesla modules and will have a BMS then.

6 months ago
Forum
Reply
RE: 12000xp and warning 28

For the very first setting on screenshot (System Discharge Power rate(%)= 40%) Have you touched that at all?Can you change it to 100%, I believe this ...

6 months ago
Forum
Reply
RE: Curious behavior - Batteries charging with BMS Charge forbidden

@eric Sounds good, thank you sir. That is what I was thinking but wanted to make sure nothing broke. Thanks again.

6 months ago
Forum
Reply
RE: EG4 wifi dongle unable to connect

@nctarheel1980@jasonCan you both send me a private message with your dongle's serial number and also a screen shot of the Dongle connect Parameters as...

6 months ago
Reply
RE: Lifepower V2’s

I’ve been in lead acid mode trying to deep cycle them so it doesn’t show them. I’ll get the BMS test done tonight and look at them. Phillip and I will...

6 months ago
Forum
Reply
RE: Lifepower V2’s

Yes, charging by voltage in lead acid mode would be the best approach. I’ve attached a document that explains how to properly top balance the batterie...

6 months ago
Forum
Reply
RE: Curious behavior - Batteries charging with BMS Charge forbidden

@joel-brodeur I believe this is normal. Since the battery is already at 100%, it likely wouldn’t be considered charging. Instead, it’s more of a maint...

6 months ago
Forum
Reply
RE: 6000XP Not exiting bypass mode for hours

For your battery bank, are you using a BMS?

6 months ago
Forum
Reply
RE: EG4 6000XP Rapidly Entering and Exiting bypass mode!

@joel-brodeur -- I found I could reproduce the problem by using a toaster and a hot water kettle at the same time. Enough to cause a voltage sag, but ...

6 months ago
Forum
Reply
RE: EG4 6000XP Rapidly Entering and Exiting bypass mode!

That makes sense, any idea how long you "high load" would be occurring if it wasn't going into bypass? The reason I ask is my old system had a preven...

6 months ago
Forum
Reply
RE: EG4 6000XP Rapidly Entering and Exiting bypass mode!

I think I've figured it out! I was able to take a slow-mo video of the screen while reproducing the problem. What's happening: A high load on the inve...

6 months ago
Forum
Reply
RE: Battery charge % and communication issue

@sjvicker is all you need for the BMS is a laptop and a cord to connect to the battery. You can download the BMS test off of the EG4 website assuming ...

6 months ago
Forum
Reply
RE: Deep Discharging - How to and how often?

Yes, that is an interesting question. I've never heard of any benefit of deep discharging. My normal practice is never below 20% and monthly top balan...

6 months ago
Page 122 / 270