I was just informed that we are working on a firmware to fix this generator cool down issue. As soon as the firmware is available, I will let everyone...

I don't believe A28 means it's a fault or warning code. You would see a frowning face if it was a warning or fault code. If it was a warning or a faul...

That happens sometimes, but the firmware versions are the same and will not impact performance.

@joel-brodeur no sir

@pawnee Yikes. Any errors in the inverter logs?

@Eric Thank you for the update

@joel-brodeur it didn’t switch back and forth from batteries to generator during shutdown. Generator stopped charging then switched to the batteries b...

@eric Iam trying to update to LCD firmware 18/1> I am using a USB flsh drive it has been going on for 45 minutes. The USB light is flashing like it...

@joel-brodeur I shut the panels off Tuesday night and the gen should about be ready to start, so I’ll let you know in a few hours.

@pawnee were you able to enable cool down? Did it help any?

@eric Bump the question.

@eric Visited with Jacqueline at SS tech support (awesome working with her, please tell @signaturesolarjess that Jacqueline deserves a raise after dea...

Here's another example from today where it stayed in bypass mode for a while with loads that could easily be handled by solar *or* PV.You're welcome t...

One Flexboss should be sufficient, but it ultimately depends on your required output. Having two will provide more power, and you’ll have the flexibil...