@wiredup you might have a look at the following thread: @signaturesolarjess discusses a way to get the BMS to reset the high and low for the S...

@wiredup Did you hear anything back on this yet? Just curious.

@jared Thanks Jared. I think I know what you are trying to say but not 100% sure. My concern is that they should all be charging and discharging at ...

No changes made by me. I did notice that some new parameters showed up in the monitoring app under settings which is why I thought there might be a fi...

Thank you brother. thats a big help and a step in the right direction! i will link the device as soon as i get back to my home computer. thanks again....

1 - It is my understanding that there is no limit on the output from the generator. The system should only draw what the system can (just make sure t...

Should i post this elswhere? if so can a mod move it or should i repoast?

@eric It is a BA dongle which was purchased in July of 2024. How does this get upgraded so the firmware can be updated to enable a complete set of ...

In order to update your dongle, you would need to have a BJ, BG or BE dongle. You can identify which dongle you have by looking at the first to letter...

Did you make any changes in your settings prior to this issue happening?

@nathanfaught We are actively working on this and will have an update soon to resolve the issue.

@jlankford I switched to Volt with a set high voltage of 59V since the BMS is set for 58.4(3.65 per cell). What happens is when one cell in each of...

@DougL Which charging control method are you using on the 18K? SOC control or Volt control? I have found that when using SOC control the 18K will ...

Were you able to get the firmware update installed?If you have the inverter online, I can update the firmware for you.

Do you have setting #3 set to GNE? Sometimes this does require a firmware update depending on what firmware the inverter is on.