@eric Thank you for your prompt reply, Eric! I have a quick follow-up question: If I have two PowerPro batteries, can I still parallel them with a si...

@joel-brodeur thank you, I checked last time did not see anything accessible but perhaps did not look close enough and will try again next visit

@og0088 Good afternoon!It is highly recommended to have three server rack batteries per PowerPro battery. As you mentioned, this setup will help maint...

Unfortunately, that would not be a recommended configuration for your systems.

Is your system online? I can certainly check and update it for you if you'd like. I would just need the station name or the inverter's serial number.

There are logs on the battery, as far as I know they are only accessible through the touchscreen on the battery.

@scottmr808 If you are able to check on the inverter - Setting 22 sub-settings AREC and EREC, you may find additional information (other faults or war...

@eric it was setting the warning 27 when I was there but it cleared up very quickly and then restarted providing power. Not sure if its still setting...

@scottmr808 I did take a look at the system but did not find anything indicating that the system is losing power. I don't see any warning or fault cod...

Unfortunately client reports it continues to drop out power ... they said 2pm 5pm and 9pm it reset yesterday. One thing comes to mind .... the 6000x...

@we2 Yeah, that is kind of what I was looking at, utilizing the 18kpv w/PowerPro’s as the primary(load connected to main panel) and have the 6k’s and ...

@eric That is kind of what I figured.

@jared Thanks for your reply. I have a quick question regarding the new EG4 LL‑S 48V 100Ah batteries. If I set up two PowerPro indoor batteries (280A...

@frugal-farmer I am not sure if the inverter rebooted or what. It shut down all loads for a few seconds seemed to be about 5 to 10 seconds si I am gue...