@jared LifePower4V2, but no way to find current firmware version until I can get registered. And I have no installer code, as I am just installing my...

@stxsolar is there any chance you have helpful info on setup without battery back up ?

So I set my SOC to 1% but the voltage is 50.92V which is higher then the 3% SOC. I understand during discharging it will read lower and during chargin...

@david993561 my large house has a central ducted (forced air) “packaged unit” which burns propane for heat and grid electricity for summer A/C. I h...

So while in closed loop I set battery to go to 3% which corresponds to 50.69 and EG4 tech support I recall them saying 46 is 20% and 44.8 goes into BM...

Looks great

@jarrett .... kinda expecting an update by now. It's pretty serious to not be able to set correct bulk/float voltages. I would hope that the 6000xp ch...

Super happy, got my 3rd battery replaced and now running all 3 seamlessly. No faults. All three were charged to 100% to 55.9V and now its 9:00am down ...

Check your inbox! I just sent an email your way

No sir. I am reaching out to a few friends that do Solar Design, and one of them only landed back in the US this morning. Hopefully, they can point me...

The Wi-Fi dongle troubleshooting guide may help you reconnect the dongle: Wi-Fi Dongle Troubleshooting Guide. Although, I would power cycle the local ...