Are you charging and discharging batteries by voltage? Meaning you have Voltage parameters set on the inverter.

@jared Well, after much noodling and acumulating all the pieces and parts, here is where I am Firmware is updated on 3 batteries to Z02T17 The dip...

Installed transfer switch before chargeverter to utilize grid or generator and set to 57v.

Yes sir. I too was delayed in getting back out to the property. I finally made it out and changed the settings. It looks very, very good, especiall...

Monthly does seem a bit excessive! and the equipment might be pricy for quality stuff. I agree, there must be an easier way. The answer should ...

Email me directly and I'll give you my inverter number and you can look it over

I think my settings were wrong and I kept blowing my 60 amp battery fuse, when that happen the negative was intact and the inverter read my voltage wr...

@eric yes, only the v1 batteries, but not the v2 batteries

Currently, there is no LCD firmware update available, but we will let everyone know as soon as there is.

You can use BMS TOOLS and BMS TEST to look at the battery details and information.

Sorry I couldn't get back to you on Friday. Were you able to switch it back?

The GridBoss can support down to 30A breakers. However, I will look into this and see if you can do a 20A breaker and if so, where you could get it.