@samjam24x7 Can you share a screenshot of what you're seeing?I would like to confirm it's not the app. If it's an issue with the app, sending another ...

@bobandroslyn I don't believe it's supposed to provide a confirmation, but it would be a good idea for them to send one. I will mention this as well. ...

@gigadude I would have to double check if we can send a replacement board or if the whole inverter would need to be replaced. Have you tested voltage ...

Why don't you just remove the wifi config (SSID and passkey),from the donglemso you are sure it cannot connect to wifi? I'd rather be sure as opposed ...

  I'm not sure I'd anyone actually tested my scenario. It's important that someone at eg4 tests it Even if I disable my cellular network the ...

Also - Should the dongle auto switch from WIFI to Ethernet if WIFI is lost?

I had done both as you suggested prior to this initial post. Doing again now to log response. 1. Unplugged the dongle and connected it again. LED's ...

The same thing happened to me after just upgrading firmware on my 3 indoor 280ah batteries. Have you figured out anything yet? I can only read one bat...

@caseysweb I just updated my 3 indoor 280ah batteries with the latest firmware and now I can only read the master battery. What did you do to resolve...

Are you communicating both batteries with the inverter? Usually, the batteries can either communicate with the inverter or the chargeverter. you will ...

@ponobillYou can use your phone and update the inverter through our EG4 app.

@caseysweb On the Flexboss, you can change the battery type to Lead Acid and set all the voltage parameters.

@james You can find it here ↓Indoor Wallmount – EG4 Community Forum

sounds like a real load.... 6-7kw would definitely show a little corresponding voltage sag. The heater in the wallmount (280ah) battery is a few hundr...

I believe I have discovered my mystery load. I installed a new high efficiency water heater last year. It has a 24.1amp load when it goes into heati...