Unfortunately, this is not possible at this time. However, I will submit a request for consideration to lower the charging voltage in a future firmwar...

Are you able to post screenshots of your settings please?

I believe this is saying you can do up to 60A for 2 inverters, 90A for 3 inverter and so on. I attached a link where someone explains how they install...

Charging and discharging by voltage for a long period of time shouldn't be an issue. When you installed the new V2 batteries, were they within 0.5V of...

@eric Thank you, Eric. No worry at all! I'm considering an alternative setup: integrating a 6000XP (or possibly a 3000EHV-48) inverter to connect the ...

This sure seems like a bug in the firmware. Can your team look into why the 6000XP would be trying to exit bypass mode 1sec after entering it?It sure ...

Thanks Eric On the Local Monitor App Under the Discharge setting tab the “Discharge Current Limit(Adc)” is set to 250 Under the Discharge settin...

@frugal-farmer It is a snip from the web monitor. Maybe just a time lag issue or something.

Is that a screen shot from the front of your controller? If yes, perhaps since your batteries are at 100% your (BMS?) required charge is not needed?

@eric thanks

Did you ever get to the bottom of this? I made a post about have related (but not identical symptoms). My inverter would go into bypass mode when load...