@eg4eric Only module light keeps blinking

Only module light keeps blinking

10.10.10.1 only works with dongles that start with the letters BA. Are all the lights on or are any of them blinking?

@nickThe 16-kWh battery is preferred as the master battery; however, if that isn’t possible, it can be added to the existing 14.3 kWh batteries withou...

@jarzzWelcome to the Forum!I’m not aware of any option to add a delay. However, when the grid goes down, you can enable Off-Grid Mode and configure th...

@eg4eric I got a support call this morning at 6:30am my time, they weren't able to diagnose online so I was supposed to get a call back at 9 but didn'...

Having this issue on a two FlexBoss21 and four 260ah all weather wall mount batteries, any updates on a fix to try?

You seem to be experiencing the same 280AH firmware upgrade issue as has been reported. We upgraded to Z02T11 (For the inside wall mounts).

This is what I get in dev view, only thing I changed is replaced the serial number with 123456789{"success": true,"serialNum": “123456789”,"lost": fal...

@slackware1995 you would need to know what type of batteries and the BMS output amperage to spec the cables for the batteries. As for the inverter it'...

Hi Eric, yes it's online, I don't see warnings or errors other than the over-current warning in the log. 43730P0310 is the one that's stuck in standby...